Front Plate Removal
#14
Here are what the 4 holes look like (4 inner holes):
The two extra outer holes were drilled for direct mounting of the plate without the plastic mount. I dremeled the outer holes and inserted square license plate mounting retainers, then cut some angled bushings to stand-off the plate from the bumper at the proper angle. Placing clear adhesaive bumpers at the middle of the plate back prevent any movement or vibration.
The two extra outer holes were drilled for direct mounting of the plate without the plastic mount. I dremeled the outer holes and inserted square license plate mounting retainers, then cut some angled bushings to stand-off the plate from the bumper at the proper angle. Placing clear adhesaive bumpers at the middle of the plate back prevent any movement or vibration.
#15
Originally Posted by SoCalHHR
Here are what the 4 holes look like (4 inner holes):
If mine has four holes...The front plate stays on
Ng
#17
I guess I was lucky that my factory plate bracket was only attached with 4 phillips head screws. No drilling required, and only 4 small holes left that I actually had to enlarge slightly to get the plastic rivet covers in.
#19
I don't have the license plate mount on my HHR. I bent the license plate and frame to match the bumper. put a piece of double sided tape( but only remove the paper from the side on the plate) so it wouldn't vibrate and bolted it directly to the black part of the bumper.
#20
Originally Posted by SoCalHHR
That picture is of a spare bumper we have. All the holes will be filled in. And the bumperettes shaved....and the line around the black insert filled...and perhaps some other mods....
Who knows!
Who knows!