When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
well, didnt do much to the new to me Panel today but i did re-purpose some tail lights off my parts Panel . I picked up a golf cart for my mom and needed to put a light kit on it and as i was looking around my shop for something to use for turn/run lights i thought hmmm what would work with the angle on the rear fender of an E-Z-Go . . . . . .
This morning, reviewed front suspension, the driver’s side inner tie rod in loose and clunks when turning either direction, musta been the same or a new pothole. Parts are ordered, sad the clearance parts at RockAuto are the same manufacturer and part number as a parts palace up here , RA clearance price $4.50 each , my parts counter guy quoted me this morning $106.00 both in CDN funds. My GM guy quoted Genuine GM part at $108.00 . The RA part wins!
One of those days...CEL came on as I was driving up to the cities, temp gauge never came off the peg, and dash temp showed -----. I reset the error code, something about a thermostat temp something.. it did not return and the temp gauge and readout started working again...
And the brakes started pulsing a bit worse than before. Time for some new pads, rotors, drums and shoes. 202xxx miles so it is probably due anyhow.
Themostat and coolant was replaced a year ago, temp is right around 178 with AC on and 83 degrees while cruising at around 70 MPH. Just had oil changed and I think they knocked something loose. worked fine on the 73 mile drive home.
Brakes I ordered are ceramic pads for the front, with new rotors, new drums for the rear with stock shoes.. I should be set!
With the front wheels off, I will be checking front end components, but they were replaced with Moog last fall too. Ya don't know until ya know I guess,
05-23-2023, 09:14 PM
. I picked up a golf cart for my mom and needed to put a light kit on it and as i was looking around my shop for something to use for turn/run lights i thought hmmm what would work with the angle on the rear fender of an E-Z-Go . . . . . .
