Toms 26 T project
#71
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Superior, WI - Over the Hill Warranty Club member
Posts: 2,999
Sides in place.
Tailgate bent and top tube tacked.
Tailgate bent and top tube tacked.
#73
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Superior, WI - Over the Hill Warranty Club member
Posts: 2,999
Stake pockets ready for one side, now for the top tube. Tailgate is ready for hinge mounting. I know I was going to go with a wood flatbed but had some 16ga that was begging to be used.
#75
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Superior, WI - Over the Hill Warranty Club member
Posts: 2,999
Thinking of this for the door
One more bend to front side and some trimming and 2 tubes to go and all of the bends are using 2 heavy angles, the back cross frame and a dead blow hammer..
Floor in the bed, might get wood floor later. Remounted the gas tank forward and lower.
Yes I changed my mind on the bed floor but it still may get a wood flat bed and sides later depending on how this looks finished.
One more bend to front side and some trimming and 2 tubes to go and all of the bends are using 2 heavy angles, the back cross frame and a dead blow hammer..
Floor in the bed, might get wood floor later. Remounted the gas tank forward and lower.
Yes I changed my mind on the bed floor but it still may get a wood flat bed and sides later depending on how this looks finished.
#77
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Superior, WI - Over the Hill Warranty Club member
Posts: 2,999
I am told my new seat back panel will arrive in the morning so I can get the front box panel bent and formed to the seat back. I have started on wiring.
#78
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Superior, WI - Over the Hill Warranty Club member
Posts: 2,999
Shortened my windshield supports, note one long one short.
Both done
Dash work
Electronic speedometer.
I would hope a 5.3 LS engine (327) should make it go at least 35 mph!!
Both done
Dash work
Electronic speedometer.
I would hope a 5.3 LS engine (327) should make it go at least 35 mph!!
#79
Senior Member
Thread Starter
Join Date: 01-13-2006
Location: Superior, WI - Over the Hill Warranty Club member
Posts: 2,999
A nice addition Note the Chevy red/orange for the powered by chevy!!