Misfire / traction control light???
08-23-2019 | 04:28 PM
#13
Thread Starter
Member
Joined: 04-30-2016
Posts: 68
From: Sheridan wy
So I have 145lbs of compression in 1.3.4 and 0 in 2.
Took a inspection camera looked into the combustion chamber and no hole in piston. Going to pull valve cover to see if I have a stuck lifter . Timing chain has not broken or failed.
Took a inspection camera looked into the combustion chamber and no hole in piston. Going to pull valve cover to see if I have a stuck lifter . Timing chain has not broken or failed.
08-23-2019 | 05:05 PM
#16
Platinum Member
Joined: 12-06-2009
Posts: 11,432
From: Alabama
Was the piston coated in oil ? As Don stated, there's only a couple ways for oil to get into the cylinder. A "stuck lifter" wouldn't be one of those ways.
Still believe you have a major failure in there.
I remember a while back a member here scoped his, didn't see any piston damage, then tore it down and found the edge of the piston broken off.
Still believe you have a major failure in there.
I remember a while back a member here scoped his, didn't see any piston damage, then tore it down and found the edge of the piston broken off.
08-23-2019 | 05:58 PM
#17
Administrator
Joined: 10-13-2011
Posts: 37,829
From: Welland,Ont Canada
08-24-2019 | 07:07 AM
#20
Administrator
Joined: 10-13-2011
Posts: 37,829
From: Welland,Ont Canada
More like a place for the cam to roll and push down on that rocker arm and force the valves open as the lobe rolls around
https://zzperformance.com/products/rocker-arms
https://zzperformance.com/products/rocker-arms