P0010 and P0107 car slow to start...
01-15-2020 | 07:40 PM
#11
Thread Starter
Member
Joined: 01-11-2013
Posts: 45
From: Tx.
If you replaced one of the VVT valves The other is sure to fail soon. What has happened is somebody replaces one the start the car and the CEL is still on so they assume it is the same problem. I speak from experience. You said That says 1 solenoid.
Most people that have to rely on AutoZone diagnosing end up getting the wrong part; in this case the camshaft position sensors. That is why I asked the question. No offense intended, No need to shout.
Those codes should clear themselves. If you clear the codes it may take 2-3 weeks before all of the OBD2 test are run.
Most people that have to rely on AutoZone diagnosing end up getting the wrong part; in this case the camshaft position sensors. That is why I asked the question. No offense intended, No need to shout.
Those codes should clear themselves. If you clear the codes it may take 2-3 weeks before all of the OBD2 test are run.
P.S. removed the ground wire and reset everything. Fired the car up and cranked right up and errors are gone, hopefully when the OBD2 test is run I have no issues.
Thread
Thread Starter
Forum
Replies
Last Post
DASH0071972@
SS Specific Service Issues/Repairs
23
07-01-2015 12:31 PM